Similar Issues
- During Startup Wizard, network check fails
- Device cannot be found in the network
- Device cannot get an IP address (Wrong IP settings)
- The Night Owl HD CMS Software is not connecting remotely.
- Night Owl HD App cannot connect while in local Wi-Fi
Troubleshooting Steps
1. Check all cable connections
• Please, check the network cable is not loose and properly connected. a Network cable must be connected from the NVR network port to one of the available LAN port in the Local Router (e.g. LAN1, LAN2 etc.)
2. Check for damaged cable or ISP Issues
• Unplug the Ethernet cable from your NVR and connect to another device (e.g. laptop) to verify the condition of the cable.
If you have internet connection on the other device, this means that the Ethernet Cable works, so you can plug the cable again on your NVR and go to Step 3 of this guide.
If you don’t have internet on the other device, either the cable is bad, or you are having a problem with your Internet Service Provider (ISP).
• Connect the NVR using a different Ethernet cable and check the network connection as indicated in the next step.
o Check for Ethernet port green and amber activity lights on the back panel of the system.
If you still don’t have Internet Connection after changing the cable, neither on the NVR or in the laptop, you must contact your Internet Service Provider (ISP).
If you can see activity lights working, please, restart your device. This will refresh the IP address assigned to the NVR by your router. After restarting, your device must have an Internet Connection. If not, please go to Step 3.
3. Check Network Settings and IP address
o Check if the IP address of the NVR is different to the default one.
NVR Series | Default IP address |
IH8 Series | 192.168.1.100 |
o Check if the IP address is set in DHCP (Static/DHCP disabled Configuration is recommended only for advanced users)
To check these parameters, please, follow the next steps:
3.1 For IH8 Series:
• Go to NVR Main Menu (You may need to log in after this step)
• General Tab will appear by default, on this Tab select Network sub-tab
• On Network sub-tab, select Main. On this screen, you can check the IP address of your device and verify if it’s set on DHCP. (If you change the settings from Static to DHCP, please, restart your device. This will refresh the IP address assigned to the NVR by your router)
4. As a last resource, default the System to the factory settings.
(Note that all current setting will be erased but not the HDD recordings)
To factory reset your device, please, follow the next link How to Factory Reset my DVR/NVR?
If all Troubleshooting Steps Fail and a Warranty Claim is needed, please Contact our Technical Support Team. Our technician will need to make sure all steps were done. Please, have the device’s model noted when you call.
Note: In order to remote connect the DVR/NVR using your smartphone or CMS, your network speed must accomplish some minimum requirements. Please, follow the next steps:
1. Use a computer with PC /MAC OS
2. Open a Website Browser and type www.speedtest.net
3. Right-clicking on Begin Test
4. See the download/upload speeds
NOTE: We recommend minimum 2 Mbps upload speed for your NVR. Consider that your Internet Connection is shared between all the devices you have in your home. So, you will need more than 2 Mbps of upload speed to have your device properly connected.
Comments
0 comments
Article is closed for comments.