- NVR is not detecting motion.
- NVR motion detection sensibility setup
- NVR motion detection area setup
If your system is having problems to detect motion, is most likely that it’s a configuration problem. Some NVRs have the option to disable the motion detection for specifics channels. Also, the motion detection sensibility and motion detection area can affect the motion detection feature in your NVR and the record of this motion event.
Note: By default, the NVR is set up to detect motion with the highest sensibility in all the area the camera can view, but if one of this parameter is changed, you may experiment a motion detection problem.
1. Make sure you are having a motion detection problem. See if, after a motion event, the motion icon is activated on the channel screen.
2. If so, please, check the motion detection sensibility and detection area setup. If the motion detection sensibility is too slow, or some areas of the camera’s field of view have been deactivated to detect motion, the NVR can miss some motion event that you would like to detect and record. To check these two parameters, please, follow the steps:
2.1. For IH8 Series:
• Go to NVR Main Menu (You may need to log in after this step)
• Click on Alarm sub-tab
• On this screen, you will be able to set up the Motion Sensibility and Motion Detection Area.
o Locate Sensitivity section to adjust the sensitivity of the motion sensor. A lower setting will require more movement in the camera’s field of view for a recording to be triggered (It’s 7 by default).
o Locate Motion Area: Selecting Setup will allow you to configure which areas in the cameras field of view will and will not detect motion. Red boxes denote areas that will detect motion and uncolored boxes denote areas that will not. When finished, right-click to return to the menu.